The SoClean filter must be manually reset by removing the filter cover and shaking out the filter.
To reset your SoClean machine, press and hold the power button for 10 seconds.
There are a few potential reasons why your SoClean may not be working. First, it is possible that the SoClean is not plugged in properly. Make sure that the power cord is plugged into an outlet and into the back of the machine. Second, it could be that the filter has been clogged up with debris. To clean the filter, turn off the machine and unplug it from the power source.
SoClean takes two hours because it is a deep clean. It uses a combination of steam, pressure and brushes to get into all the nooks and crannies.
There is not a recall on SoClean machines.
There are a few ways to reset your CPAP machine:-Power off the machine, wait 10 seconds and power it back on.-Remove the battery, wait 10 seconds and replace it.-Press and hold both buttons for at least 10 seconds.-Wait for the machine to restart.
To check if your SoClean is working, you can press the green light on the front of the machine to turn it on and then wait a few seconds for it to turn off. If the light stays on, then your machine is not working and needs to be replaced.
There are a few potential causes of why your CPAP machine may not be turning on. The most common is that the power cord is not plugged in properly. Make sure the cord is plugged into the electrical outlet and into the back of the machine. If that doesn’t work, check to see if the machine’s batteries are dead. Try plugging in the machine and turning it on, then checking to see if the machine shows an error message or starts up automatically.
Yes, you can use CPAP right after using SoClean. However, it is important to follow the instructions that came with your CPAP device.
Yes, the ozone in SoClean is safe.
